Double side light up card

Hello there everyone and happy Monday! It’s Wei Wei here. Today I’ll be sharing how to make double side light up card.

There’s a video of the process at the end of this post if you want to watch that instead of reading.

In the front of the card, when I press the button, the UFO lights up! And then, while open the card, there are birthday party held inside and the UFO also lights up!

The photo above, I show you the circuit I used in my card.

In the front side, the switch is the same as I used before, I cut a sheet paper which function just like “pull-tab”. The mechanics attached underneath the “pull-tab” is the thing that two squares folded in half, butting up against each other and wrapped with copper tape. When the card is closed, the “pull-tab” can not bridge the gap in the circuit. On the contrary, when the card is opened, the “pull-tab” can bridge the gap in the circuit to turn the lights on.

In the back side, I made a simple circuit, but left a little gap for the switch. How to make LEDs light up? I added a conductive fabric tape patch to the back side of the pattern paper, and I also adhered a “press here” button.  In this way, the LEDs light up when I press the button.

Thanks for stopping by!
The supplies I used are:
Double side light up card

One thought on “Double side light up card

  1. Very fun card! The stamps are adorable, and the addition of the lights makes the card so special!

Comments are closed.

Scroll to top
Chibitronics