Hi everyone!! It’s Wei Wei here with this interactive card showcasing Craft with Light Kit – Color and Pressure Sensitive Conductive Plastic.
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9848-1024x1024.jpg)
This card is designed as a circuit with a pressure sensor. If you press down on the switch, yellow and red lights will light up first, followed by pink and blue lights in order.
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9842-1024x1024.jpg)
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9843-1024x1024.jpg)
The circuit has been completed using the Fabric Conductive Tape and LED Stickers. I also used a piece of paper as a bridge when an overlap of the positive and negative traces was needed, to prevent a short circuit.
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9844-1024x1024.jpg)
After completing the circuit, I added a pressure sensitive conductive plastic on the battery holder.
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9845-1024x1024.jpg)
The circuit I used, the one that lights up in a sequence, is a parallel circuit with a single switch, a pressure sensor, that interrupts the negative lead in its unpressed state. When I press down gently on the conductive plastic, at first, none of the lights turn on. As I press harder, the lights show up in order.
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9851-1024x1024.jpg)
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9852-1024x1024.jpg)
![](https://chibitronics.com/wp-content/uploads/2022/10/IMG-9853-1024x1024.jpg)
That is all from my side today. Thank you.